5000 Series Aluminum Alloys Products with Low Magnesium Percentage

Application:

Aviation, marine and car manufacturing industries


Certified ByTrust

Product Introduction:

5000 group products with low magnesium have good properties such as: corrosion

resistance and good strength. For this reason, these products are used as heat exchangers, fuel and food storage tanks, and functional sheets. Various aviation, marine, and automobile industries are among the centers where these materials are used. Aluminum alloy with 2 or 3% magnesium only recovers during hot deformation.

Due to incomplete DRX occurrence, by increasing of magnesium to more than 4% and secondary phase precipitation, hot deformation will face applicability problems; However, in small amounts of magnesium, significant inhomogeneity does not occur, and alloy preparation and casting also face less challenges.

After casting in the rolling line, the aluminum slab is first cut, and then, if a suitable surface quality is needed or if we want to eliminate surface defects caused by casting, it is chipped; After that, the slab will be transferred to the preheating furnaces. The selection of the furnace temperature in the assembly is mainly based on the melting temperature of the alloy. The heated slab reaches a thickness of 7 mm after several hot rolling passes.

The design of the rolling stages will generally be based on the power of the device, increased applicability and microstructure design. The cold rolling of the alloy is done in a four-roller cold rolling machine, and for this alloy, it will continue up to a thickness of 0.4 mm. After cutting the sheet (depending on the type of order), it will be annealed.

Technical Specifications:

* The amount of magnesium is less than %4

* Thickness up to 0.4 mm

* Sheet width can be changed according to orders

Advantages:

High added value

Company

Type

This product is a final B2B consumer product.

Main Export Destinations

,

SKU: 10004 Category: 
Product Categories
My Cart
Categories