Nano Barium Sulfate Used in the Battery Industry

Application:

In the battery industry, for the formation of lead sulfate during battery charging and discharging periods


Certified ByTrust

Product Introduction:

Synthetic barium sulfate is produced from the reaction between barium carbonate salt and nitric acid and then ammonium sulfate. For this purpose, first, 1000 liters of water is poured into the 3000-liter reactor, then barium carbonate

is added into it at the same time by stirring the contents of the reactor, and after that, nitric acid must be added into the reactor. After finishing adding nitric acid, ammonium sulfate, which is already dissolved in water, is added to the reactor.

By adding ammonium sulfate to the reactor, barium sulfate will be produced simultaneously. After completing this step, the contents of the reactor are stirred for 2 hours to consume raw materials that did not react. The produced product is sent to the 5000 liter reactor and washed several times with distilled water to minimize the impurities in the mixture. In each step of washing, the impurity level of the solution inside the reactor is measured, and after the electrical conductivity of the water reaches less than 150 microsiemens, the slurry is transferred to the dryer, and finally, the product is dried, milled and packed.

Company

Type

This product is a final B2B consumer product.

SKU: 11122 Category: 
Product Categories
My Cart
Categories